NXP Semiconductors FS4500 - Fig. 3. Evaluation Board Description; Tab. 3. Board Description

NXP Semiconductors FS4500/FS6500 evaluation boards
KTFRDMFS4500-FS6500EVMUG
FS4500/FS6500 evaluation boards All information provided in this document is subject to legal disclaimers. © NXP B.V. 2017. All rights reserved.
User guide Rev. 4.0 — 12 June 2017
8 / 34
aaa-025543
Figure 3. Evaluation board description
Table 3. Board description
Number Description
1 V
BAT
connector - Use Phoenix connector to supply board
2 FS45xx / FS65xx
3 Ignition key - Ignition key from car
4 Power supplies - Connector for power supplies (V
PRE
/V
CORE
/V
CCA
/V
AUX
)
5 Power supplies LED - Visualizes regulator state (on or off).
6 V
DDIO
selection - Selects either V
CCA
or P3V3_KL25Z (3.3V supply from FRDM-KL25Z board)
7 Enable DBG mode
8 Can & LIN connector - Could be used for debug purpose (CANH, CANL, LIN)
9 I/Os - Input and Output from FS45XX/FS65XX (SPI, V
PRE
, FS0b, TX LIN)
10 I/Os - Input and Output from FS45XX/FS65XX (IO2, IO3, IO4, IO5, Ignition)
11 I/Os - Input and Output from FS45XX/FS65XX (RSTb, FS1b, DBG, GND, P3V3_KL25Z)
12 I/Os - Input and Output from FS45XX/FS65XX (TX CAN, RX LIN, CAN_5V, V
CORE
, V
CCA
, V
AUX
,
V
KAM
, V
DDIO
)