EasyManua.ls Logo

Oberheim DX - MIDI Edit Parameters (07-14)

Oberheim DX
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EDIT PARAMETERS
MIDI EDIT PARAMETERS
(also see "
ABOUT MIDI"
07 RECEIVE CHANNEL (1-16)
This sets the MIDI Channel that the DX receives on. If OMNI MODE (Parameter
09)
, the OX wil receive on ALL channels.
08 TRANSMIT CHANNEL
(1-16)
This sets the MIDI Channel that the DX sends MIDI intormation on.
09 OMNI MODE
On)
When OMNI MODE is on
, the DX will receive MIDI information on ALL 16 channels.
When off
, the DX wil only receive information on the RECEIVE CHANNEL
. set on
EDIT PARAMETER
07.
This OMNI MODE command is also received and transmitted
via MIDI
, on the RECEIVE and TRANSMIT channels set aDove.
10 MIDI CLOCK OUT(-
On)
This turns on the MIDI timing clock
, for slaving other Sequencers and Drum Machines
via MIDI. See the INTERFACE GUIDE for more information.
11 ECHO NOTES
On)
If on
, any notes that appear at the MIDI IN will be retransmited to the MIDI OUT. The
Song Select message wil be echoed as well.
12 SONG CHANGES
On)
This enables the Song Select MIDI command. When on
, Song numbers are transmit-
ted and received by the DX. This way, the master MIDI controller can select a particu-
lar Song to be played by slaved machines. Song Select does not transmit or receive
Sequence numbers
, and wil only select Songs when in Stop.
13 SET DRUMS
TO
MIDI NOTES
On MIDI drum machines
, the drum buttons are transmitted as MIDI notes. This fUnc-
tion allows you to set a MIDI note to particular drum button. Playing a note into the
MIDI IN
while holding a drum button sets the note to that drum. Playing a note into the
MIDI IN while holding ERASE sets the note not to play any drums. A drum can be pro-
grammed to several notes. but a note can only be programmed to one drum. These
MIDI notes must be within a 32 note range.
Pressing RECORD and COPY resets the notes to default settings (see the diagram in
the "INTERFACE/MIDI NOTES" section). Presing RECORD and
ERASE clears all
settings.
14 SET TRANSPOSITION
The range of the MIDI notes can be set with this edit parameter. Hold RECORD and
press the note desired to be the bottom of the range. The MIDI note number wil
appear in the display.
See the "
INTERFACE/MIDI NOTES" section for more information.
NOTE: The phrase "
any combination of drums
" means any combination of up to 6
qrums with a limit of one drum per voice. Thus pressing LOUD BASS and SOFT BASS
has the same effect as only pressing LOUD BASS (on all columns of drum buttons
. the
lowest button has priority).

Table of Contents