OHAUS Defender 3000 - Appendix B: MT-SICS Commands

Defender 3000 Indicators EN-53
9.2 Appendix B
MT-SICS Commands
Command
Function
LEVEL 0
@
Reset the scale
I0
Inquiry of all available SICS commands
I1
Inquiry of SICS level and SICS versions
I2
Inquiry of scale data
I3
Inquiry of scale software version
I4
Inquiry of serial number
S
Send stable weight value
SI
Send weight value immediately
SIR
Send weight value repeatedly
Z
Zero the scale
ZI
Zero immediately
LEVEL 1
D
Write text into display
DW
Weight display
SR
Send and repeat stable weight value
T
Tare
TA
Tare value
TAC
Clear tare
TI
Tare immediately
Command
Function
LEVEL 2
C2
Calibrate with the external calibration weight
C3
Calibrate with the internal calibration weight
I10
Inquire or set scale ID
I11
Inquire of scale type
P100
Print out on the printer
P101
Print out stable weight value
P102
Print out current weight value immediately
SIRU
Send weight value in the current unit immediately and repeat
SIU
Send weight value in the current unit immediately
SNR
Send stable weight value and repeat after every weight change
SNRU
Send stable weight value in the current unit and repeat after every weight
change
SRU
Send weight value in the current unit and repeat
ST
After pressing the Transfer key, send the stable weight value
SU
Send stable weight value in the current unit
LEVEL 3
M01
Weighing mode
M02
Stability setting
M03
Autozero function
M19
Send calibration weight
M21
Inquire/set weight unit
PRN
Print out at every printer interface
RST
Restart
SFIR
Send weight value immediately and repeat quickly
SIH
Send weight value immediately in high resolution
SWU
Switch weight unit
SX
Send stable data record
SXI
Send data record immediately
SXIR
Send data record immediately and repeat
U
Switch weight unit