OHAUS Defender 3000 - Readout Menu Settings

Defender 3000 Indicators EN-33
4.4 Readout Menu
Enter this menu to set user preferences. Default settings are in bold.
Menu
Sub-Menu
Sub-Menu (in
segment)
Options
Options ( in segment)
Read Out
(r.E.A.d)
Reset
reset
no, yes
NO, yes
Stability
Stable
0.5d, 1d, 2d, 5d
0.5d, 1d, 2d, 5d
Zero Range
ZErO
2%, 100%
2, 100
Filter Level
FIltEr
Low, Medium, High
LOwW, mMEd, HIGH
Auto Zero Track
AZt
Off, 0.5d, 1d, 3d
OFF, 0.5d, 1d, 3d
Back Light
B.LIGHt
Off, On, Auto
OFF, ON, AUtO
Back Light Color
b.COLOr
Green, Yellow, Red,
Amber
Green, red, Yellow,
AmMber
Screen Saver
SCrEEN
Off, 1min, 2min, 5min
OFF, 1, 2, 5
Auto Off
A.Off
Off, 1min, 5min, 10min
OFF, 1, 5, 10
PWM.SAVE
P.SAuEr
ON, OFF
ON, OFF
CEC
CEC
ON, OFF
ON, OFF
End
End
/
/
Note: / refers to not applicable in the table above.
Reset [reset]
Reset the readout menu to factory defaults.
NO = do not reset.
YES = reset
Stability [StAblE]
Set the amount reading can vary before the stability symbol turns off.
0.5d = 0.5 of a scale division
1d = 1 scale division
2d = 2 scale divisions
5d = 5 scale divisions
Zero [ZErO]
Set the percentage of scale capacity that can be zeroed.
2% = zero range is within +/-2%
100% = zero range is within +/-100%
Filter [FILtEr]
Set the amount of signal filtering.
LOwW = faster stabilization time with less stability.
mMEd = normal stabilization time with normal stability.
HIGH = slower stabilization time with more stability.
AZT [AZt]
Set the automatic zero tracking feature.
OFF = disabled
0.5d = the display will maintain zero until a change of 0.5 of a divisions per second has been
exceeded.
1d = the display will maintain zero until a change of 1 division per second has been exceeded.
3d = the display will maintain zero until a change of 3 divisions per second has been exceeded.
Backlight [B.LIGHt]
Set the display backlight feature.
OFF = backlight is disabled.