EN-44 Defender 3000 Indicators
i-DT33XW
6. MAINTENANCE
CAUTION: DISCONNECT THE UNIT FROM THE POWER SUPPLY BEFORE CLEANING.
6.1 Cleaning
For i-DT33P, the housing may be cleaned with a cloth dampened with a mild detergent if necessary.
For i-DT33XW, use approved cleaning solutions for the stainless-steel Indicator housing and rinse with water.
Dry thoroughly.
WARNING: Electric Shock Hazard. Disconnect the equipment from the power
supply before cleaning.
Make sure that no liquid enters the interior of the instrument.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning
agents.
Figure 5-9. i-DT33XW Sealing (Connecting cable with connector and memory module)
Figure 5-10. i-DT33XW Sealing (Connecting cable with connector and without memory module)
To Next Page
