Oki B4100 Maintenance Manual

42640901TH Rev.1 41 /
Oki Data CONFIDENTIAL
3. ADJUSTMENT
This chapter explains adjustment necessary when a part is replaced.
This adjustment is made by changing the parameter values set in EEPROM on the main control board.
The status monitor or maintenance utility can be used to change these values.
Only servicemen and maintenance personnel can use the maintenance utility. This utility cannot be
made public for printer end users.
3.1 Adjustment Types and Functions
3.1.1 Status Monitor
Please refer to Status Monitor.
3.1.2 Maintenance Utility
A operation method of Maintenance Utility, please refer to Maintenance Utility Operating
Specifications.
3.2 Adjustment When Replacing a Part
Adjustment is necessary when replacing any of the following parts.
Part Replaced Adjustment
Image Drum Cartridge
Main Control Board
Reset the image drum counter
(refer to User's manual).
EEPROM data Upload / Download
3.2.1 Uploading/Downloading EEPROM data
When the controller printed circuit board is replaced, the contents of the old EEPROM shall be copied
to the new EEPROM on the new board to preserve customer settings. For the purpose, use the
Maintenance Utility.
A operation method of Maintenance Utility, please refer to Maintenance Utility Operating Specifications.
The maintenance utility is designed to be used only by field engineer and it should not be released to
the end-users.

Oki B4100 Specifications

Performance

print speed	19 pages per minute
CPU	200 MHz
time to first page	6.0 seconds
print resolution	1200 x 600 dpi
duty cycle	15, 000 pages per month

Memory

standard RAM	8 MB
maximum RAM	8 MB

Paper Handling

standard paper input	250-sheet Letter/Legal/Universal tray
paper size minimum	3.4" x 5.5"
paper size maximum	8.5" x 14"

Weight and Dimensions

size (WxDxH)	14" x 15.6" x 7.9"
size (WxDxH in cm)	35.5 cm x 39.5 cm x 20 cm
weight	22 lb. (10.0 kg)