42640901TH Rev.1 64 /
Oki Data CONFIDENTIAL
8 White vertical belts or streaks
• Are the LED lens dirty?
• Yes Clean the LED lens.
• No Is the contact plate of the transfer roller in proper contact with the high voltage/sensor board
(see Figure 5-5)?
• No Adjust the contact plate to make a proper contact with the high voltage/sensor board.
• Yes Replace the transfer roller.
• Has the problem been solved?
• Yes End
• No Is the tension between the back-up roller (7.52kg) and the surface of back-up roller normal?
•No Replace the back-up roller or bias spring.
• Yes Is the LED head being installed properly (check HEAD connector on the main control board
and PC connector on the LED head)?
• No Install the LED head properly.
• Yes Replace the LED head.
• Has the problem been solved?
• Yes End
• Yes Replace the image drum cartridge.
• Has the problem been solved?
• Yes End
Note:
After replacing the image drum cartridge. Reset the drum counter (see User's
Manual).
• No Replace the main control board or high voltage/sensor board.
To Next Page
Loading...
