43502101TH Rev.1 57 /
Oki Data CONFIDENTIAL
DescroptionLED
Table 5-1 (3/5)
Status level LCD
Warning
Warning
Warning
Warning
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
■■
FILE IS WRITE PROTECTED
■■
INVALD ID.JOB REJECTED
■■
LOG BUFFER FULL.
JOB REJECTED
■■
FILE OPERATION FAILED nnn
MANUAL
mmmm REQUEST
tttt
DUPLEX REQUEST
LOAD mmm
tttt EMPTY
CLOSE COVER
TRAY2 COVER OPEN
CHANGE PAPER TO mmmm/
pppp
tttt MEDIA MISMATCH
CHANGE PAPER TO mmmm/
pppp
tttt SIZE MISMATCH
RS232C
OVERFLOW
RS232C
OVER RUN
RS232C
PRY ERR
RS232C
FRM ERR
CONFIG
WRITING
NETWORK
INITIAL
DL MSG
FAILED n
CHANGE CARTRIDGE
TONER EMPTY
Varies
Varies
Varies
Varies
Light
Light
No Light
No Light
No Light
No Light
No Light
No Light
No Light
No Light
Varies
Varies
Varies
No Light
An attempt to write in a write-protected file was made.
Because this is a transient warning, it is displayed until the job is
completed. then, cleared.
Notifies a user that the job has been cancelled as permission for printing
has not been received.
This is displayed until the ON LINE key is pressed.
Notifies a user that the job has been cancelled as the log buffer is
full. This is displayed until the ON LINE key is pressed.
There was unauthorized access in the flash memory.
Acquire a log with JOB Accounting system.
Manual print request. Prompts the user to set paper indicated by
mmmm manually.
Paper feeding is recommended because the print of back sides
(odd number pages) is finished during the Manual Duplex print.
JOB is canceled if a paper isn't put even if it passes through the
time when it is set up with "MAN TIME".
Indicates that a print request was sent to the tttt tray that has
become empty. A message for setting mmmm paper.
TRAY1
TRAY2
MPF
Print request has been made to the 2nd tray route cover open.
To continue, close cover.
The media type in the tray and the edit media type do not match.
TRAY1
TRAY2
MPF
The paper size in the tray and the edit size do not match.
TRAY1
TRAY2
MPF
RS232C Overflow has Occurred.
To continue, press ON-LINE switch.
RS232C Over Run has Occurred.
To continue, press ON-LINE switch.
RS232C Parity Error has Occurred.
To continue, press ON-LINE switch.
RS232C Framing Error has Occurred.
To continue, press ON-LINE switch.
During the network menu renewal.
Initializing (rebooting) a section related to NIC.
Writing the download message data failed.
"n" shows the reason for failure
1:FAIL
2:DATA_ERROR
3:OVERFLOW
4:MEMORYFULL
5:UNSUPPORTED_DATA
Toner Low has passed, and almost no toner is left in the cartridge.
For temporary operation, open/close the cover or press "ON-LINE"
switch, to recover the printer operation. But basically you must
change the toner cartridge.
To Next Page
Loading...
