Oki B6500

B6500 Network User’s Guide
Printing from UNIX - 32
-C Option (LPR Command)
This section explains the functions which can be specified and printing
operations which will be affected by the -C option.
The -C option is available only when the SunOS directs the printer to enter
the spool mode.
Important:
When the PostScript logical printer that was configured on the printer
web page and -C option of "lpr" command have been specified
simultaneously, some of the actions cannot be guaranteed to work.
Also, when specifying the PostScript logical printer as a default printer
on Unix, it is recommended not to user the -C option by "lpr"
command.
Function
The following items can be set up by using the -C option:
NOTE
Any parameter other than below becomes invalid if specified.
Selecting a Paper Tray
When selecting a paper tray, either the paper size or the tray itself is
specified. If the paper size is specified, the printer automatically searches
and selects the tray where the specified paper is loaded.
The following parameters can be specified:
NOTE
Parameter Description
INTRAY1/intray Selects Tray 1.
INTRAY2/intray2 Selects Tray 2.
INTRAY3/intray3 Selects Tray 3 (option).
INTRAY4/intray4 Selects Tray 4 (option).
A4/a4 Selects the tray where A4 paper is
loaded.
B5/b5 Selects the tray where B5 paper is
loaded.
A5/a5 Selects the tray where A5 paper is
loaded.
LETTER letter Selects the letter size.
LEGAL/legal Selects the legal size (8.5 x 14).