Oki B6500

B6500 Network User’s Guide
Troubleshooting - 53
Using EtherTalk
Unable to obtain desired print results.
Treatment
Cause 1
The print language of the printer and that of the print
drawer are different.
Verification 1 Check the print language set up for the printer and
that for the printer driver for Macintosh.
Action 1 Ensure that PostScript and Adobe PS are set up as
the print language for the printer and printer driver
respectively.
If the print language of the printer is the dump
mode, the print data sent from Macintosh will be
output in hexadecimal notations.
Cause 2 The printer driver which came with the printer is
not set up on the Macinotosh. A printer driver of
another maker has been used instead.
Verification 2 Check the installation procedure for the printer
driver which came with the printer again and
confirm that the printer driver is installed on the
Macintosh.
Check that the printer driver which came with the
printer appears in the Chooser.
Action 2
If garbled characters are still printed after the printer
driver for the printer has been selected, contact service.
If a printer driver of another maker is used, the printer
may not print properly.