Oki B6500 - Setting IP Address

B6500 Network User’s Guide
Troubleshooting - 57
Setting IP Address
When the printer is connected to the network, it retrieves the IP address
automatically from the DHCP server once it is switched on.
If the DHCP server is not available or not in use, use one of the following
methods to retrieve and set the IP address.
> Set the IP address from the control panel
> Use the IP address Setup Tool in the CD-ROM bundled with this
printer.
Important:
> When using the DHCP server, use WINS (Windows Internet
Name Service) server at the same time.
> The address information can also be retrieved automatically
via the BOOTP or RARP servers. For such cases, change the
[Get IP Address] selection on the control panel to [BOOTP] or
[RARP].
> Depending on the network environment, you may need to set
the subnet mask and gateway address.
> Please check with your network administrator if you have any
questions concerning your network environment.
Refer to:
> Details on retrieving IP address: Reference Guide
> IP Address Setup Tool: Network Print Environment User Guide
> Web browser: Reference Guide
NOTE
> You can change the IP address using a web browser.
> You can check the current IP address, subnet mask and gateway
address settings from the [System Settings List].
> This section explains how to set IP address from the control panel.
NOTE
> If you have made a mistake when operating the control panel,
press the <MENU> button to restart.