- 103 -
5. Management / Setting the Printer
Initializing
This section describes how to initialize memory and settings saved in the machine.
You can delete data or settings stored on the printer to restore the settings to how they were
at the time of purchase.
• In order to access the [Admin Setup] menu, an administrator password is required. The default password is
"123456".
• Initializing Flash Memory
• Initializing the Network Settings
• Initializing the Settings of the Device
Flash memory stores data such as form data, etc.
Use the following steps to initialize.
• When you initialize flash memory, the following data is deleted.
- Data stored in [Shared Print] or [Private Print]
- Form data
1
Press the scroll button several times to select [Admin Setup] and press the
«ENTER» button.
2
Enter the administrator password using the numeric (0-9) keys, and press the
«ENTER» button.
• The factory default administrator password is "123456". If the administrator password is changed, enter the
updated password.
3
Press the scroll button to select [Others Setup] and press the «ENTER»
button.
4
Press the scroll button to select [Flash Memory Setup] and press the
«ENTER» button.
5
Select [Initialize] or [Format Partition] and press the «ENTER» button.
6
When [Execute] is displayed, press the «ENTER» button.
• Select from 2 ways of initializing memory.
- [Initialize]: Initializes the range of open area of Flash (displayed on File List).
- [Format Partition]: Initializes user information. You can format the PCL/Common/PS partitions respectively.
7
Press the scroll button to select [Yes] on the confirmation screen, and
press the «ENTER» button.
To cancel initialization, select [No] in this screen.
Initializing Flash Memory
To Next Page
Loading...
Need help?
General
