16 - English
Install the Driver(s) and Utilities
1 Make sure the printer is off.
2 Insert the CD supplied with the printer in the
CD-ROM drive. The CD will AutoRun. (If it
doesn’t, go to the CD’s main directory and
double click [setup.exe].)
3 Select your language.
4 Accept the license agreement.
5 Click [Driver Setup].
6 Click [Install Driver].
7 Select local printer.
8 Select the LPT1: port. Click Next.
9 Select [OKI C910], then select the
emulation(s) to install (PCL, PS).
10 Follow the on-screen instructions.
Install the User’s Guide
If you also wish to install the User’s Guide pdf:
1 With the CD still in the CD-ROM drive, click
[User Guides].
2 Click [Install User Guide] and follow the on-
screen instructions.
Macintosh Network
Installation
Make the Network Connection
Important!
In order to reduce electromagnetic
interference—”noise” that interferes with
TVs or other appliances—you must install
the included ferrite core on the network
cable.
Note
The Ethernet cable and hub are not included with
your printer.
1 Turn off the printer and the computer.
2 Loop the cable as shown and place the ferrite
core supplied with the printer about 1 inch
(25 mm) from the connector on the printer
end.
3 Connect the end of the Ethernet cable with
the ferrite core to the printer.
4 Connect the other end of the cable to a
suitable hub.
To Next Page
Loading...
Need help?
General
