沖データ企業秘密・OkiDataCONFIDENTIAL
45530603TX - 15/130
Note 1) Transparencies may become wavy after they are printed.
Note 2) A thin film of toner may be printed over transparencies, or images printed on
transparencies may be lighter than those user-specified.
Note 3) Transparencies may lower the fusibility of toner.
Note 4) Transparencies with slippery coatings may not be fed.
Note 5) Output print quality may degrade on transparencies, which are made of
transparent plastic.
Note 6) Using non-recommended transparencies for a printer may cause failure of the
printer.
e) Postcards
Postcards can be fed only from a standard auto feeder tray (1st tray) and an MPT.
Japanese postal cards and non-folded Japanese double postal cards can be used.
Table8．Postcard Specifications
Size
Japanese
Postal Card
Single: 100mm x 148mm General postal cards except for ink-jet printing or with
photographs attached on them
Japanese
Postal Card
Double: 148mm x 200mm General postal cards except for ink-jet printing or with
photographs attached on them
The following postcards should not be used:
• Japanese postal cards for ink-jet printing;
• 2-mm or more warped postcards;
• Postcards with stamps; or
• Postcards printed with photographs.
Note 1) Postcards may become warped after they are printed.
Note 2) A thin film of toner may be printed over postcards or images printed on postcards
may be lighter than those user-specified.
Note 3) Postcards may lower the fusibility of toner.
Note 4) Pro9541WT is not supported Postcards.
Double Single
(f) Labels
Labels can be fed from the Auto-feeder Tray and the MPT of C911/C931/C941.
Labels meeting the following conditions should be used for the MPT:
• The sheets of the labels are A4,B5 and letter size.
• The labels are electrophotographic printer or dry PPC ones that do not deform, and of
which glue or base paper do not deform, by heat;
• The labels do not peel from their base paper in the thermal fusing process of the
To Next Page
Loading...
Need help?
General
