Oki C9650dn Network And Configuration Guide

Using TELNET > 47
U SING TELNET
E XAMPLE TELNET CONFIGURATION
TELNET requires the print server to have a valid IP address
configured. If the NIC already has an IP address configured, skip
steps 1 to 3 below.
1. Use the PING command to confirm the connection with
the network card.
Example
For IP address 172.168.20.127:
ping 172.168.20.127
If there is no reply, there is a problem with the
configuration of the IP address (the IP address has been
already set manually or by the DHCP/RARP server), or with
the network. Reset the network interface card settings to
the default and try to set a temporary IP address. If you
still have the problem after resetting the network interface
card, consult the network manager.
2. Login to the network card using TELNET.
Example
For IP address 172.168.20.127
telnet 172.168.20.127
CAUTION!
Please ensure that a valid IP address for your network
environment is used. Use of an incorrect IP address
can cause serious problems on your network.
NOTE
The method of configuring commands may differ between
workstations. Refer to the workstation’s manual.

Oki C9650dn Specifications

Performance

print speed color	36 ppm
print speed mono	40 ppm
time to first page color	10.5 sec
time to first page mono	9 sec
warm-up time	85 sec
resolution	1200 x 600 dpi

Memory

standard RAM	512 MB
maximum RAM	1, 024 MB
flash memory	4 MB
hard disk drive	40 GB

Power

power consumption operating typical	780W
power consumption peak	<1500W
power consumption standby	200W
power consumption power save	33W

Weight and Dimensions

size	23.6" x 24.6" x 18.5"
weight	167.5 lb
weight with consumables	76.0 kg