4
4-1 Fiery Setup from the Control Panel
Setup is required the first time the printer is turned on after installation or if the hard
disk drive has just been replaced. In this initial Setup, you (or the service technician)
choose the language for Printer Control Panel menus and messages. If you do not
configure a particular Setup option, the Fiery uses default settings. Make sure the
settings are appropriate for the printing environment at your site.
Fiery Setup from the Control Panel
Setup performed from the Control Panel configures the Fiery to communicate with
other devices and manage print jobs sent to it.
Setup provides these groups of options:
• Server Setup to specify system options
• Network Setup to specify all the active network systems that transmit print jobs to
the Fiery
• Parallel Setup to determine if and how the parallel port is used
• USB Setup to determine if and how the USB port is used
• Printer Setup to specify how print jobs and queues are managed
• PS Setup to specify PostScript settings
• PCL Setup to specify PCL settings
• Color Setup to specify colour settings
• Job Log Setup to specify how the Fiery handles its log of printed jobs
• PrintMe Setup to specify the PrintMe settings
• Custom Process to specify special custom colour settings
• Change Password to create and change the administrator password
• Language to select the required language for the display panel and various printed
reports
• Clear Server clears all print jobs from the server
• Factory Defaults restores factory default settings
Chapter 4:
Performing
Setup from
the Control
Panel
To Next Page
Loading...
Need help?
General
