4
4-9 Network Setup options
8. When you have finished entering protocol settings, choose Exit Protocol Setup, and
then choose Service Setup.
9. Enter the appropriate settings for the services you will use.
The options are described in detail in the following section.
TO EXIT NETWORK SETUP
1. When you have finished entering service settings, choose Exit Network Setup.
2. Choose Yes when prompted to save changes.
3. From the main Setup menu, choose another Setup or choose Exit Setup.
Port Setup options
You can enable Ethernet, USB and parallel communication simultaneously. To
configure the Fiery, choose each port type you use and enter the settings for that
port. Since network setups are nested, the names of higher-level menus are shown in
this chapter to the left of each menu heading.
Network Setup
Port Setup
Ethernet Setup
Enable Ethernet
Yes/No [Yes]
Select Yes if you have Ethernet cabling connected to the Fiery.
Ethernet Speed
Auto Detect/100 Mbps/10 Mbps [Auto Detect]
Select Auto Detect if your network environment is mixed or if you do not know the
network speed. If you know the speed of the network to which the Fiery is attached
(10Mbps or 100 Mbps), select it.
To Next Page
Loading...
Need help?
General
