4
4-20 Performing Setup from the Control Panel
Service Setup options
PServer is a program in the Fiery software that services the Novell print queues
assigned to the Novell print servers set up for printing to the Fiery. When you choose
PServer Setup and enable PServer, you can set up NDS (Novell Directory Services),
Bindery Services, or both.
LPD Setup options
PServer Setup options
Network Setup
Service Setup
LPD Setup
Enable LPD
Yes/No [Yes]
Select Yes to allow lpd printing. For more information, see “Setting up the Fiery on
TCP/IP networks” on page 2-19.
Network Setup
Service Setup
PServer Setup
Enable PServer
Yes/No [No]
Select Yes if you have a Novell network connected to the Fiery.
Choose NDS Setup if your network uses NetWare in native mode. Choose Bindery
Setup if your network uses NetWare in bindery emulation mode.
If your network uses both NDS and Bindery, set up NDS first. If you set up NDS
after Bindery, you will overwrite Bindery Setup.
If your network uses both NDS and Bindery, and uses NetWare servers in bindery
emulation, note that the Fiery cannot service NDS and bindery emulation servers
on the same NDS tree.
To Next Page
Loading...
Need help?
General
