4
4-7 Network Setup options
Network Setup options
When you perform Network Setup, you configure the Fiery to receive print jobs over
the network systems used at your site.
In the Setup menu, choose Network Setup, to specify network addresses and names to
be used by workstations, servers, and the Fiery when they communicate with each
other.
The Network Setup menu includes three submenus that allow you to choose port
types, protocols, and network services. You must perform Port Setup and enable at
least one port. When multiple ports are enabled, print jobs can be received over all of
those ports at the same time. If the Fiery is configured to enable more than one
protocol, it automatically switches to the correct protocol when it receives a print job.
For each item you enable, you are prompted to enter settings for that item. Default
values, where applicable, appear in this manual with square brackets.
You should display and select options only for the network systems that are currently
used at your site. If your network requirements change, you can change Network Setup
at any time.
To Next Page
Loading...
Need help?
General
