5
5-8 Setting up the Fiery from a Windows Computer
Ignore EOF Character. —Available only if Enable Parallel Port is selected, this option specifies that the Fiery
should ignore end-of-file (EOF) messages. Select this option to print PostScript files in
binary format (not ASCII); under normal circumstances, this option should not be
selected. When this option is selected, the Fiery uses the parallel port timeout value to
determine when the end of the file has been reached.
Parallel Port Timeout (seconds). —Available only if Enable Parallel Port is selected, this setting determines how
long the Fiery waits without receiving data from the parallel port before deciding that
the current job is complete. Until the timeout, the Fiery cannot receive new jobs
through the parallel port, but it can continue to receive network print jobs.
Protocols
You can change TCP/IP, AppleTalk and IPX/SPX protocol settings for the Fiery.
Change these settings on the Protocol1 and Protocol2 tabs.
To Next Page
Loading...
Need help?
General
