Oki ColorPainter M-64S - External Dryer System Installation

39
Printing on reflective sheeting
Installing the external dryer system
External dryer system installation procedure
Install the external dryer system to the printer.
WARNING

The location on the front of the printer and the external dryer system where the high temperature
warning sticker is axed becomes very hot. Never touch this location. Otherwise, there is a risk of burn.
1
Handles
Cables
Place the external dryer system near the front
of the printer.
Notes

Place the external dryer system so that its leg comes to
the right side of the printer legs.

Pay attention that the cable connected to the external
dryer system does not get caught into or under the
external dryer system casters when moving the system.

To move the external dryer system, hold it by the
handles shown in the gure. Touching a dierent part of
the external dryer system may cause a burn.
2
< Maintenance area side >
< Capping unit side >
Make the magnet on the external dryer
system adhere to the metal plate of the
printer.

The gure shows the equipment seen from above.
Note

Make sure that the magnet of the external dryer system
is securely adhering to the printer when installing the
external dryer system.
Before printing
Printing on
reective sheeting
Maintenance
Advanced
operations
Troubleshooting Menu tree Appendix