Oki ColorPainter M-64S - External Dryer Heater Operation

70
Advanced operations
Heater operation of the
external dryer system
Display the control menu of the external dryer system
Press the HEATER button to display the heater control menu.
In the heater control menu, pressing the HEATER button switches the display between the media heater control
menu, the external dryer system control menu and the online state, as shown below.
PRINTER READY
07: RFLTIV/1219mm D
HEATER

If a media preset with the reective sheet mode
set to on is selected, the temperature settings
of the media heaters cannot be adjusted from
the panel (printing is performed with the
temperatures set in the data).
2nn
55 40 45°C
Aft 40 +40 45Pre
HEATER
2nn
ON
Ext READY
HEATER
2nn
ON
Ext READY
External dryer system
control information
External dryer system status
External dryer system warming state
When the heater control menu display ends automatically
HEATER DISPLAY ENDED
If no buttons are input for 30 seconds while the heater control menu is displayed, the message HEATER DISPLAY
ENDED appears automatically for two seconds and then the heater control menu display ends. While this message
is displayed, no button input is eective.
The display changes
to end automatically.
The display changes
to end automatically.