Oki ColorPainter M-64S - Procedure to Remove the Roll Media (Output Side)

50
Printing on reflective sheeting
Procedure to remove the roll media (output side)
Notes

Right after printing, the reective sheeting is extremely hot because it has been warmed by the external
dryer system. Wait for a while and check that the reective sheeting is cool before removing it.

The optional cutter cannot be used.
1
Feed the media until all the printed part that
will be used has passed the output paper
guide.
2
Cut the media slightly after the edge of the
output paper guide.
Note

Pay attention not to damage the output paper guide
with the cutter.
3
Check that the guide bar is in the standby
position and pull the TUR unit toward you.
Hold the front pipe of the TUR unit and pull it toward you.
4
Install the media jack at the maintenance
area side.
Notes

Do not let the media jack fall.
Otherwise it may be damaged during use.

Do not grab the moving parts when taking the media
jack.
Otherwise, your ngers may get caught in the moving
parts, leading to an injury.