Oki ColorPainter M-64S - Removing Media After Printing

49
Printing on reflective sheeting
Removing the media
Procedure to print the amount of remaining media
The amount of remaining media can be printed on the media before removing the media.

Printing the amount of remaining media before removing it allows you to refer to it to enter the exact amount of
remaining media the next time you install the same media.
Refer to page 68 in the IP-6620 Color Inkjet Printer User’s Guide.
Removing the external dryer system
WARNING

The location on the front of the printer and the external dryer system where the high temperature warning sticker is axed
becomes very hot. Never touch this location. Otherwise, there is a risk of burn.

The external dryer system is connected to the printer with a cable. Do not separate the external dryer system from the
printer by a distance longer than necessary. Otherwise, it may pull the cable and cause a disconnection.
1
Handles
Cables
Separate the external dryer system from the
printer.
Notes

Pay attention that the cable connected to the external
dryer system does not get caught into or under the
external dryer system casters when moving the system.

To move the external dryer system, hold it by the
handles shown in the gure. Touching a dierent part of
the external dryer system may cause a burn.
Before printing
Printing on
reective sheeting
Maintenance
Advanced
operations
Troubleshooting Menu tree Appendix