Oki ColorPainter M-64S - Procedure to Monitor Remaining Media; Replacing the Media When the End of the Roll Is Reached; Replacing the Media after a Media Jam; Setting the Media Remaining Length

33
Printing on reflective sheeting
9
>>>>MEDIA MISMATCH
2
ON
Press the Down button to select OFF.
10
>>>>MEDIA MISMATCH
2
OFF
Press the OK button.
11
>>>>MEDIA MISMATCH
2
OFF
Notes

After the media has been installed, check that the media does no enter the gap formed by the cutter blade (option) or
that it is not caught in the media clips (options). Also check that the media evenly contacts the platen and that it does
not wrinkle.

When back feeding 30 cm or more of the media, do not back feed the entire length at once but perform the back feed
operation while winding the media by hand to remove any slack that is forming.
Procedure to monitor remaining media
Refer to page 53 in the IP-6620 Color Inkjet Printer User’s Guide.
Replacing the media when the end of the roll is reached
Refer to page 59 in the IP-6620 Color Inkjet Printer User’s Guide.
Replacing the media after a media jam
Refer to How to clear a media jam on page 231 in the IP-6620 Color Inkjet Printer User’s Guide.
Setting the media remaining length
Refer to page 59 in the IP-6620 Color Inkjet Printer User’s Guide.
Before printing
Printing on
reective sheeting
Maintenance
Advanced
operations
Troubleshooting Menu tree Appendix