Oki ColorPainter M-64S - Page 51

51
Printing on reflective sheeting
5
①
②
Remove the left side rst.
1 Turn the media jack’s handle clockwise to raise the
media jack to the level of the media.
2 When the jack supports the media, slide the left media
holder to remove it from the media roll.
Notes

Do not raise the media jack too high when the media is
still installed on the media holder. Doing so may damage
the media holder or the media jack.

Pay attention not to insert you ngers into the moving
pantograph mechanism or otherwise touch it during
operation.
6
Place the left side of the media on the media
support.
1 Install the media support next to the jack.
2 Turn the media jack’s handle counter-clockwise to lower
the media until it is supported by the stand.
7
Slide the media jack and install it to the right
side.
8
①
②
Next, remove the right side.
1 Turn the media jack’s handle clockwise to raise the
media jack to the level of the media.
2 When the jack supports the media, slide the right media
holder to remove it from the media roll.
Notes

Do not raise the media jack too high when the media is
still installed on the media holder. Doing so may damage
the media holder or the media jack.

Pay attention not to insert you ngers into the moving
pantograph mechanism or otherwise touch it during
operation.
9
Turn the media jack’s handle counter-
clockwise to lower the media, and then
remove the media.
Notes

The media is heavy. Always use two or more people when handling roll media to prevent injury, such as when the
media fall over someone’s feet. Also, if you feel that the media is too heavy, take measures to handle it properly such
as increasing the number of people carrying out the operation. Incorrect handling of the media may lead to personal
injury.

To prevent injuries, use a dolly equipped with a lifter (recommended dolly) when loading, removing or replacing the
media.
Before printing
Printing on
reective sheeting
Maintenance
Advanced
operations
Troubleshooting Menu tree Appendix