Getting started > 21
section provides general advice on choice of media, and explains
how to use each type.
The best performance will be obtained when using standard 20
~24 lb. (75~90g/m²) paper designed for use in copiers and laser
printers. A suitable types are
> Hammermill
®
Laser Printer Radiant White, 24 lb. US Bond
(90 g/m
²
)
> Xerox
®
4024, 20 lb. US Bond 20 lb. (75 g/m
²
)
> Oki
®
52206101 Bright White Proofing Paper, 32 lb. US
Bond (120 g/m
2
)
Use of heavily embossed or very rough textured paper is not
recommended.
Pre-printed stationery can be used, but the ink must not offset
when exposed to the high fuser temperatures used in the printing
process.
Envelopes should be free from twist, curl or other deformations.
They should also be of the rectangular flap type, with glue that
remains intact when subjected to hot roll pressure fusing used in
this type of MFP. Window envelopes are not suitable.
> Oki
®
Premium Envelopes (size #10)
52206301 (100 count)
and
52206302 (500 count)
Transparencies should be of the type designed for use in copiers
and laser printers. We strongly recommend Oki transparencies
(Order No. 52205701). In particular, avoid office transparencies
designed for use by hand with marker pens. These will melt in the
fuser and cause damage.
Labels should also be of the type recommended for use in copiers
and laser printers, in which the base carrier page is entirely
covered by labels. Other types of label stock may damage the
printer due to the labels peeling off during the printing process.
Suitable types are:
> Avery 5161 White Laser Label (Letter size)
> Avery 7162, 7664, 7666 White Laser Labels (size A4).
To Next Page
Loading...
Need help?
Printer Specifications
Paper Handling
