Oki ML1190 - Page 30

ML1120/ML1190 User’s Guide - Paper handling > 30
NOTE
• Specickindofmediamayaffecttheaccuracyofreliningdue
to passage load of the media. In this case, use the printer with
Paper Guide erected.
• Specickindofmediamaycauseslippingandthelastsheet
maynotbeejected.Conrmwellbeforeusing.
Paper Guide: Paper Guide; erected
normal (Relining accuracy will be improved.)
• When using Bottom Tractor, parts of sheets put together by the
stapler may stick together, thus feeding two pages at the same
time, resulting in paper jam. In this case, unfasten the pile of
sheets before feeding. Further, if jams occur due to the pile of
the paper, use of Rear Tractor is recommended.
• When continuous paper of
3-4” width is used, move Paper
Guide (L) to the middle of the
paper.
• Under the circumstance of high
temperature and high humidity,
the paper become frail and
galley of sprocket hole and
paper jam tend to occur.
When the paper is to be set
in Tractor, adjust the position
of Tractor so that will not get
loose or too tense. (Fit the pin
of Tractor with the center of the
sprocket hole.)
Pin tractor
Pin tractor
Paper guide
Paper guide (L)