ML1120/ML1190 User’s Guide - Operating instructions > 62
MENU ITEM FUNCTION SETTING
Set-up menu Operator panel
function
Select full or limited
operation.
Full operation
Limited operation
Reset inhibit Set whether to enable
or disable an initial
command.
No
Yes
Print suppress
effective
Set whether to enable or
disable a print suppress
setup command.
Yes
No
Auto LF Select whether to perform
auto LF operation or not
upon receiving a CR code.
Yes
No
Auto CR Select whether to perform
auto CR operation upon
receiving a carriage return
command.
IBM PPR and IBM AGM
emulation only
Yes
No
SI select pitch (10
CPI)
Set how to handle an SI
command received in 10
CPI mode.
IBM PPR and IBM AGM
emulation only
15 CPI
17.1 CPI
SI select Pitch (12
CPI)
Set how to handle an SI
command received in 12
CPI mode.
IBM PPR and IBM AGM
emulation only
12 CPI
20 CPI
Time out print Select valid or invalid.
Valid
Invalid
Auto Select Select whether to
automatically set Select
Mode after paper feeding
or not.
Yes
No
Host Interface Select interface settings.
Auto Interface
Parallel
USB
Serial
I/F Time Out Select timeout time for
auto interfacing.
15 sec
30 sec
45 sec
1 min
2 min
3 min
4 min
5 min
To Next Page
Loading...
