Consumables and accessories > 71
9. Holding the sides of the ribbon guide slope it downward until the ribbon guide comes
in line with the slot of the print head.
10. Move the print head horizontally to ensure that the ribbon is properly installed.
11. Turn the knob (1) clockwise (in the direction of the arrow) to wind up the ribbon.
NOTE
Ensure that the guide is pushed to the end of the print head.
CAUTION!
> Do not turn the knob anticlockwise as the ribbon might jam.
> Make sure that the ribbon is not twisted or damaged when it goes
through the gap between the Print Head and the ribbon guide.
1
To Next Page
Loading...
