Oki Pro8432WT - Page 50

- 50 -
How to Print from the MP Tray
2
2. Printing Basic Operation
Note
● The paper may be wrinkled or curled after printing.
● Use paper stored in proper temperature and humidity
conditions. Do not use paper that is curled or waved
because of humidity.
● Do not print on the back side of paper on which other
printer has printed.
● Curling of a postcard or an envelope may cause the ink
absorbing problem. Use paper that is not curled. Correct a
paper Curling within 2 mm.
7 Close the paper set cover (5).
5
If always printing on same size or type paper
from the MP tray, register the paper on the
operator panel. If printing once, proceed to the
step 18.
Note
● When a printer is in the power saving mode, press
the <POWER SAVE> button to restore from the
mode.
● Make sure that the message “Ready To Print” is
displayed in the operator panel. If the message is not
displayed, press the <ON LINE> button.
8 Press the <Fn> key.
9 Enter “90” using the numeric keypad
and then press the <ENTER> button.
10 When [Paper Size] is displayed, select
the size of the loaded paper and then
press the <ENTER> button.
Reference
● If [Custom] is selected for [Paper Size], you need
to register the custom size. For how to register the
custom size, refer to “Printing in Custom Sizes”
P.52.
11 Press the <BACK> button until
[MPTray Cong] is displayed.
12 Press the scroll button to select
[Media Type] and then press the
<ENTER> button.
13 Press the scroll button to select the
type of the loaded paper and then press
the <ENTER> button.