Oki Pro8432WT - Page 81

- 81 -
Other Error Messages
3
3. Troubleshooting
Error
code
Message
<ATTENTION>
indicator
Cause/Remedy
480 Remove Paper
Output Tray
Please see HELP for details
Blinks The printed paper is overlled on the paper
stacker of the printer unit.
Error 480 : Output Tray
519 Press ONLINE Button for Restoration
Receiving Data Timeout
Please see HELP for details
Blinks When receiving data by Port9100, LPR, FTP,
IPP, WSD, or Email, a timeout occurred in
stream.
IPv4 Address is conicted
Change IPv4 Address
Varies IPv4 address is conicted.
Getting target IP failed. Please check DHCP
settings.
Varies Indicates that DHCP server is not found out.
Wait a Moment
Network Initializing
Varies This appears when the NIC initialization is
occurred, as the setting was changed.
Wait a Moment
Network Conguration writing
Blinks This appears during the NIC conguration
data is storing into the ash memory, as the
setting was changed.
709 Caution, unknown Consumable detected
Go to User Manual “Trouble Shooting” to
restore operation
Blinks You can use any consumables in your
product, but you must accept the risks of
using non-genuine consumables. If the use
of non-genuine consumables causes damage
to the product or results in your product
not functioning to its full specication, then
such damage or effect on the product is not
covered by warranty. To accept these risks
and to restore function;
1. Turn off your product
2. Press and hold the <CANCEL> button
and turn your product on
3.
After start up, release the < CANCEL >
button
Note
This operation will be recorded for future
reference.