Oki Teriostar LP-1040 Series - Page 137

137
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
T
Setup Items in PDL Settings Menu
n
Printer Driver (only with HP-GL)
The parameter species the operation mode for the LP-1040's printer driver.
When the LP-1040's printer driver is operated with other drivers, set the parameter
to Enabled.
<Parameter by selecting options>
n
: Default value
Not Enabled When the Printer operates with the printer driver for LP-1040
installed, select Not Enabled to prioritize the PDL settings
with the operation panel over the driver settings.
Note

When the driver is disabled, some items are
aected.
Items aected by the driver settings are listed in
the table on the following page.
n
Enabled When the Printer operates with the printer driver for LP-1040
installed, select Enabled to prioritize the driver settings over
the PDL settings with the operation panel.
However, when the Printer receives data from the other
printer driver, the PDL settings with the operation panel is
prioritized.
User Dened When the Printer operates with the printer driver for LP-1040
installed, select User Dened to print on the user-dened
series roll and to prioritize the driver settings over the PDL
settings with the operation panel.
With this setting, the data output from the driver
automatically selects the user-dened series roll, and is
printed with the actual size.
However, when the Printer receives data from the other
printer driver, the PDL settings with the operation panel is
prioritized.
Note

The default value varies depending on the Printer initialization category.
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6