Oki Teriostar LP-1040 Series - Humidity for Tracing Paper; Power Saving in Standby; Print Density

91
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
T
Printer Engine Menu

Print Density
Adjusts the print density.
<Parameter by selecting options>
n
: Default value
Low
Slightly Low
n
Normal
Slightly High
High

Humidity for Tracing Paper
The parameter species the print mode for tracing paper.
<Parameter by selecting options>
n
: Default value
n
Normal Species the print mode for the tracing paper printed
under the normal environmental condition.
High Humidity Species the print mode for the tracing paper printed
under the high-humidity environmental condition.

Power Saving in Standby
This parameter species how energy is saved when the Printer is in standby.
When the parameter is set to Medium or High, power consumption can be
reduced even without entering the power save mode.
However, when printing, warm-up time may be longer and the Printer may not be
able to print immediately.
<Parameter by selecting options>
n
: Default value
n
O Power saving is low, but warm-up time is short.
Medium Power saving is fairly high, but warm-up time is fairly long.
High Power saving is high, but warm-up time is long.
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6