Oki Teriostar LP-1040 Series - Page 139

139
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
T
Setup Items in PDL Settings Menu
n
Language (only with HP-GL)
With this parameter, the received data is handled as HP-GL or HPGL/2.
When Auto is selected, the data is automatically identied.
The selection of HP-GL or HP-GL/2 aects the coordinate origin denition.
<Parameter by selecting options>
n
: Default value
n
Auto The parameter identies HP-GL or HP-GL/2 automatically.
HP-GL The parameter identies the received data as HP-GL.
HP-GL/2 The parameter identies the received data as HP-GL/2.
z
With HP-GL, the coordinate origin is at the center of the print area, while with HP-
GL/2, it is at the bottom left.
z
No error occurs even if HP-GL/2 data is received with HP-GL selected.
n
Terminator PG1;
n
Terminator NR;
n
Terminator SP0;
n
Terminator ESC.)
n
Terminator AF;
n
Terminator AH;
n
Terminator FR;
Each parameter above species the print end.
Be sure to set the Terminator SP0 to O when you apply SP0 to your drawing pen,
or your pen 0 is taken as a terminator.
<Parameter by selecting options>
n
: Default value
O Does not set the command as a terminator (EOF).
n
On Sets the command as a terminator (EOF).
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6