Oki Teriostar LP-1040 Series - Page 278

278
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation

List of HP RTL Printing Commands
The meaning of the symbols in the table is as follows.
Yes: Indicates commands supported by the Printer.
Partially: Indicates commands whose functions are partially supported by the Printer.
No: Indicates commands not supported by the Printer.
If the Printer receives any non-supported commands, it ignores them. If a command that
is not in the table is received, it results in a command error.
Command
Function Supported
Name Code
Enter HP-GL/2 Mode ESC % # B Transitions to HP-GL/2 mode. Partially (
1
)
Enter PCL Mode ESC % # A Transitions to PCL mode. Partially (
2
)
Reset ESC E Resets. Partially (
3
)
Universal Exit Language/Start of
PJL
ESC % # X Starts PJL. No
Apple Talk Conguration ESC & b # W [bin data] Communicates with the Apple Talk driver. No
Congure Image Data ESC * v # W [data] Congures the image data. Partially (
4
)
Set Red Parameter ESC * v # a|A Sets the red parameter. Yes
Set Green Parameter ESC * v # b|B Sets the green parameter. Yes
Set Blue Parameter ESC * v # c|C Sets the blue parameter. Yes
Assign Color Index ESC * v # i|I Assigns the color index number. Partially (
5
)
Push/Pup palette ESC * p # P Pushes or pops the palette. Partially (
6
)
Source Raster Width ESC * r # s|S Sets the source raster width. Yes
Source Raster Height ESC * r # t|T Sets the source raster height. Yes
Move CAP Horizontal (Decipoints) ESC & a # h|H
Performs CAP horizontal movement
(decipoints).
Yes
Move CAP Horizontal ESC * p # x|X Performs CAP horizontal movement. Yes
Move CAP Vertical ESC * p # y|Y Performs CAP vertical movement. Yes
Y Oset ESC * b # y|Y Sets the Y direction oset. Yes
Destination Raster Width ESC * t # h|H Sets the destination raster width. Yes
Destination Raster Height ESC * t # v|V Sets the destination raster height. Yes
Raster Line Path ESC * b # l|L Sets the raster line path. Yes
Negative Motion ESC & a # n|N Species a negative movement. Yes
Set Graphics Resolution ESC * t # r|R Sets the graphics resolution. Yes
Start Raster Graphics ESC * r # a|A Indicates the start of raster graphics. Yes
End Raster Graphics ESC * r C Indicates the end of raster graphics. Yes
Transfer Raster Data by Plane ESC * b # V [data] Transmits the raster data in plane units. Yes
Transfer Raster Data by Row/Block ESC * b # W [data] Transmits the raster data in row/block units. Yes
Set Compression Method ESC * b # m|M Sets the compression method. Yes
Foreground Color ESC * v # s|S
Sets the RGB value of the specied index
number as the lower limit for raster printing.
No
Render Algorithm ESC * t # j|J
Species the algorithm for expressing neutral
color data.
Partially (
7
)
(1/2)
T
Command Lists
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6