Okofen PELLETRONIC TOUCH - Heat Main Pump Function

To Next Page

To Previous Page

HeatingMainPump

28HeatingMainPump

HeatingMainPumpisintheMainmenu.

Ifnoreturntemperaturesensorofthereturnpump

isconnectedtothesystem,theHeatingMainPump

appearsautomaticallyintheMainmenu.Each

heatingcontrollerthereisamaximumofoneheat

mainpumppossible.YouswitchtheHeatingMain

PumpONandOFF .TheHeatingMainPumpisa

backuppump.Youassignthepumptoallavailable

pumpsinthesystem.Whenyouclickonanicon,it

lightsupgreen.Agreeniconsymbolisesanassigned

pump.

Note

AHeatingMainPumpandaReturnPump

excludethemselves.

E1389EN2.0

OperatingmanualPelletronicTouch

Main Page

Table of Contents3
Dear Customer5
Use Only for the Purpose Intended6
Types of Safety Warning Sign7
Pelletronic Heating Controller and Operating Device with Touch Screen8
- Operating Device with Touch Screen8
- Opening Window8
- Chimney Sweep9
- User Controls and Their Function10
- Main Menu12
Mode13
Measuring Values14
Heating Circuit16
- Measuring Values Heating Circuit17
- Time Programme Heating Circuit17
- Party19
- Vacation19
- Heating Curve and Heating Limits20
- Screed Programme24
Domestic Hot Water (DHW)25
- Measuring Values Domestic Hot Water26
- Time Programme DHW26
DHW Return Pump27
- Measuring Values DHW Return Pump27
- Time Programme DHW Return Pump28
- Solar29
- Measuring Values Solar29
- Solar Circuit30
- Yield - Solar Energy31
- Pellematic32
- Permanent Operation32
- Measuring Values Pellematic33
- Full Power34
- De-Ashing System34
- Fresh Water Module35
- Boiler Cleaning35
- Suction System36
- Level Detection System37
- Heat Main Pump38
- General39
- Favorite 1 and 239
- Local Settings40
- Malfunction41
- Information41
- Software42
- Code Input43
- Start up44
- Description of the Heating Controller Module45
- Setting the Address at the Heating Controller46
- Setting the Address at the Burner Controller47
- Setting the Address at the Boiler Controller CMP48
- Assembly or Disassembly of the Power Supply49
- Assembly and Disassembly of the Heating Controller Board50
- Description of the Operating Device Module51
- Replacing a Touch Operating Device51
- Software52
Configuration52
Activating the Function Room Thermostat52
Update Heating Controller, Touch Operating Device and Remote Control53
Software Update53
Periphery Learning54
Heating Circuits Settings55
DHW Settings57
DHW Return Pump Settings59
Solar Settings60
Solar Energy Settings63
Accumulator Settings64
System Controlling66
Cascade Settings68
Existing Boiler71
Pellematic Settings73
Measuring Values73
Ignition Settings73
Full Power Settings74
Run on Time Settings75
Output Settings76
De-Ashing System Settings76
Boiler Cleaning77
Washing78
Settings79
Boiler Controlled Pump80
FRT Controller81
Negative Draft82
Heating Main Pump83
General Settings84
Sensor Adjust84
Output Test85
Factory Setting85
Usb86
Appendix87
Calibration87
Connection Plan89
Wiring Diagrams93
Cable Specification Pelletronic Touch95
Hydraulic Connecting Diagrams96
Default Values and Settings103

Okofen PELLETRONIC TOUCH - Heat Main Pump Function

Table of Contents

Other manuals for Okofen PELLETRONIC TOUCH