Need help?Do you have a question about the Okofen PELLETRONIC TOUCH and is the answer not in the manual?
Specifies the system's design purpose and restrictions.
Explains the different types of safety warning symbols and their meanings.
Describes the touch screen interface for system control and visualization.
Explains navigation icons, buttons, and the numeric keyboard interface.
Displays the main menu and explains how to access submenus.
Explains the different operating modes for the heating system, circuits, DHW, and solar.
Overview of how to view current settings and measured values for system components.
Provides an overview of the entire heating system's operational status.
Covers mode, room temperature settings, and time allocation for heating circuits.
Details how to set heating times using Time 1 and Time 2 programmes.
Explains temporary heating extension and holiday programme features.
Explains adjustment of heating curve, base point, and temperature limits.
Allows setting specific flow temperatures for screed drying over a period.
Configures DHW modes, boost, and temperature settings.
Sets the domestic hot water usage times via time programmes.
Configures pump release temperature, switching, and time allocation.
Sets the DHW return pump usage times.
Explains operating modes and settings for solar circuits.
Measures and displays solar thermal system yield and logs previous days' data.
Details modes like permanent operation and full power.
Displays all measuring values for the Pellematic system.
Configuration for de-ashing, burner plate cleaning, and boiler cleaning cycles.
Settings for fresh water module, boiler cleaning, and suction system.
Settings for the level detection system for pellet storage.
Configures favorite menu items and local settings like language and units.
Displays fault messages and lists all faults chronologically.
Adjusts the address switch for heating, burner, and boiler controllers.
Procedures for power supply and circuit board assembly/disassembly.
Details the procedure for exchanging the integrated Touch operating device.
Explains configuration of Touch Controller as Master or Slave.
Details how to activate the room thermostat function.
Provides the approach for performing firmware and software updates.
Sets max/min flow temperatures and configures mixer types.
Manages mixer operation rate and boiler load smoothing.
Configures DHW priority, temperature increase, and legionella protection.
Covers limit sensors, overheating protection, and collector protection.
Controls solar pump speed and configures scavenging processes.
Adjusts solar energy flow rate and monitors yield data.
Configures accumulator temperature thresholds and pump operation.
Manages accumulator pump speed regulation and prevents cycling.
Manages common operation of multiple pellet boilers.
Settings for integrating an existing boiler into the system.
Protects the system from freezing by scavenging circuits and setting temperatures.
Configures ignition parameters and full power settings for the burner.
Manages fan run-on times and output settings for motors and valves.
Configures de-ashing system parameters like run time and duration.
Configures washing function and other Pellematic operational settings.
Manages negative draft and washing for condensing boilers.
Adjusts sensor values and calibrates the touchscreen interface.
Tests connected devices and restores original factory settings.
Used for recording data and loading settings via USB stick.
Step-by-step guide for calibrating the touchscreen display.
Illustrates electrical connections, wiring diagrams, and terminal layouts.
Details cable specifications and shows hydraulic schematics for various system configurations.
Lists default values and settings for customer and system parameters.
General| Power supply | 230V AC |
|---|---|
| Protection class | IP30 |
| Resolution | 480 x 272 pixels |
| Type | Controller |
| Compatibility | ÖkoFEN pellet heating systems |
| Display | Touchscreen |
| Features | Remote control, Weather-compensated control |
| Ambient temperature | 0°C to 40°C |
| Storage temperature | -20°C to 60°C |
| Interface | Ethernet, USB |
| Communication | Ethernet |
To Next Page
