Oldham MX 43 User Manual

8 – Main Part Numbers
51
5. Hardware troubles records
This displays, for each material incident detected: incident ID, status
(activated = ON or deactivated = OFF) as well as the date and time of
occurrence or release of the event.
Previous page, Next page, and Last page allow access to the corresponding
pages of the file: each page can display a maximum of 8 lines.
Message
Significance
DEAD
Digital module no longer responding (line cut, module failure, wrong address,
module absent).
MODUL
Configuration or module address error.
TEMP+
Internal temperature of the MX 43 higher than maximum tolerated value.
TEMP-
Internal temperature of the MX 43 lower than maximum tolerated value.
BAT
Switching to external power supply.
LINE 1
Incident on line 1 (short-circuit).
LINE 2
Incident on line 2 (short-circuit).
LINE3
Incident on line 3 (short-circuit)
LINE4
Incident on line 4 (short-circuit).
LINE 5
Incident on line 5 (short-circuit).
LINE 6
Incident on line 6 (short-circuit).
LINE7
Incident on line 7 (short-circuit).
LINE 8
Incident on line 8 (short-circuit).
CAL O
Calibration defect (zero shifted).
CAL S
Calibration defect (used cell).
CAL F
Calibration defect (cell oversensitive).
CAL D
Calibration defect (measurement unstable).
Table 16: Material incidents file messages.
6. System troubles records
This displays the events relative to MX 43 operation (power failure/fluctuation,
On/Off, etc.).
Previous page, Next page, and Last page allow access to the corresponding
pages of the file; each page can display a maximum of 8 lines.
Message
Significance
ON
MX 43 on live voltage
OFF
MX 43 off voltage
Self-testing failure
Failure of internal tests
Other messages
Contact Post-Sales Service
Table 17: System incidents file messages.
3. Slave info
These data enable maintenance technicians to visualize the communication
framework between MX 43 and the digital modules.

Oldham MX 43 Specifications

General

Brand	Oldham
Model	MX 43
Category	Controller
Language	English