d-Color MF 3300/3800 1-17
1.5 Available operations in Administrator mode
1
[Date/Time Settings] - [Time Adjustment Settings]
To display: Administrator mode - [System] - [Date/Time Settings] - [Time Adjustment Settings]
Using the NTP (Network Time Protocol) server, you can automatically adjust the date and time of this ma-
chine.
Register the NTP server used. To periodically adjust the date and time by connecting to the NTP server, spec-
ify an interval for adjusting the date and time.
If time zone is specified, the standard time obtained from the server adjusted to your time zone is specified
as the correction time.
[Date/Time Settings] - [Daylight Saving Time Settings]
To display: Administrator mode - [System] - [Date/Time Settings] - [Daylight Saving Time Settings]
Specifies daylight saving time for the current country setting.
Item Description
[Time Adjustment] To automatically adjust the date and time of this machine using the NTP server,
select [Enable].
[Disable] is specified by default.
[NTP Server Address] Enter the NTP server address.
Use one of the following formats.
• Example of host name entry: "host.example.com"
• Example of IP address (IPv4) entry: "192.168.1.1"
• Example of IP address (IPv6) entry: "fe80::220:6bff:fe10:2f16"
[Port Number] If necessary, change the NTP server port number.
Normally, you can use the original port number.
[123] is specified by default.
[Time Zone] Select a time zone (time difference from world standard time) to suit your en-
vironment.
[GMT] is specified by default.
[Adjustment Time] Displays the latest date and time at which time correction was performed by
connecting to the NTP server.
Item Description
[Daylight Saving Time] Select [Enable] to use daylight saving time.
Also enter the time to be adjusted for daylight saving time (in minutes).
[Disable] is specified by default.
To Next Page
Loading...
Need help?
General
