1-62 d-Color MF 3300/3800
Available operations in Administrator mode
1
1.5
[SNMP Settings]
To display: Administrator mode - [Network] - [SNMP Settings] - [SNMP Settings]
Configure the settings for obtaining the machine information and monitoring the machine using SNMP (Sim-
ple Network Management Protocol).
Item Description
[SNMP Settings] Configure the SNMP settings.
[SNMP] Select whether or not to use SNMP.
[Enable] is specified by default.
[SNMP v1/v2c (IP)] Select whether or not to use SNMP v1 or SNMP v2.
[Enable] is specified by default.
[SNMP v3 (IP)] Select whether or not to use SNMP v3.
[Enable] is specified by default.
[UDP Port] If necessary, change the UDP port number.
[161] is specified by default.
[SNMP v1/v2c Settings] Configure the SNMP v1/v2c settings.
[Read Community
Name]
Enter a read-only community name (using ASCII characters of up to 15 bytes,
excluding spaces, \, ,' ,", and #).
[public] is specified by default.
[Write] Select whether or not to enable the read and write functions.
[Enable] is specified by default.
[Write Community
Name]
If [Write] is set to [Enable], enter the community name in the read-write enable
state (using ASCII characters of up to 15 bytes, excluding spaces, \, ,' ,", and
#).
[private] is specified by default.
[SNMP v3 Settings] Configure the SNMP v3 settings.
To Next Page
Loading...
Need help?
General
