Test Programs Maintenance Manual
Test No./
Function Outline
• Press the [Start] button to pause the operation at the break point.
• The speed can be changed during the pause.
• When an error occurs, the loader displays the same error code as in the regular operation, and then
stops.
• Press the [Quit] button, and the A-arm returns to its initial position and the loader stops the operation.
A-arm
horizontal
movement
check
<A-arm horizontal movement check>
This program can be used to check the A-arm horizontal movement.
Select the operation speed using the menu buttons on the liquid crystal panel.
[M1]: High speed <Fast speed> [M2]: Medium speed <Middle speed> [M3]: Low speed <Slow
speed>
• If you do not specify anything here, the loader will operate at the high speed [M1]: High speed
<Fast speed> setting.
Press the [Start] button.
If the loader has not been initialized, initialization starts.
① Press the interlock switch and the [Start] button.
② FOUP Door open. (AL120-LMB12-LP3 only.)
③ When the door opens completely, release your hand from the interlock switch, and press the [Start]
button. (① to ③ are for AL120-LMB12-LP3 only.）
④ Moves to upper limit height.
⑤ Center of Macro table → Cassette side
⑥ Cassette side → Center of Macro table
⑦ Center of Macro table → Standby position
⑧ Standby position → Cassette side
⑨ Cassette side → Standby position
⑩ Standby position → Center of Macro table
The loader then repeats steps ⑤ to ⑩.
• The operation will not start if a cassette is set on the elevator.
• Press the [Start] button to pause the operation at the break point.
• The speed can be changed during the pause.
• When an error occurs, the loader displays the same error code as in the regular operation, and then
stops.
• Press the [Quit] button, the A-arm returns to its initial position. Then, if you press the [Start] button or
the [Quit] button while pressing the interlock switch of the FOUP opener, the FOUP door closes and
the loader stops the operation.
A-arm moves horizontally to the cassette installation part at high
speed.
When the FOUP Door opening and shutting part is carelessly looked
into, it is likely to injure in A-arm that moves.
Do not continue the operation for longer than 5 minutes.
Wait for longer than one minute before restarting the operation.
To Next Page
Loading...
