161
USING A PERSONAL
COMPUTER
Make sure that the power of the personal computer and the
camera are OFF.
Connect the RS-232C PC serial cable to the computer’s serial
port.
Remove the lens cap, and connect the cable to the camera’s
Computer connector.
Set the Mode dial on the camera to .
Start CAMEDIA Master on the computer.
5
4
3
2
1
Note:
• Do not connect when the power of the camera is on as it may cause a
camera malfunction.
• Use of the optional AC adapter is recommended for computer
downloads.
• Camera functions will be disabled while the camera is connected to a
computer.
• The computer cannot communicate with the camera while the camera is
connected to a TV.
To Next Page
Loading...
