107
Remote control shooting
5
Advanced shooting
TIPS
The self-timer/remote control lamp does not blink after pressing
the shutter button on the remote control device.
→ The remote control device may be too far from the camera. Move
closer to the camera and press the shutter button on the remote
control device again.
→ The battery in the remote control device is running low. Replace
with a new battery. g“How to replace the battery (CR2025) of
the remote control device” (P.245)
How to cancel the remote control mode.
→ The remote control mode is not canceled automatically after
shooting. Perform Step 2 and set the mode to off (No indication).
• If the remote control receiver is exposed to strong light, the
effective signal distance may be reduced or shooting may not take
place.
• To shoot sequential shots using the remote control device, press
and hold the shutter button on the remote control device. If the
camera does not receive the remote control signal properly,
sequential shooting may stop.
Note
To Next Page
Loading...
