210
10
Direct printing
Connecting the camera to a printer
Use the USB cable provided to connect the camera to a PictBridge-
compatible printer.
1 Set the camera’s USB mode to PRINT.
g“USB setup – Selecting the connection destination” (P.197)
• Have the card containing the pictures you want to print selected.
2 Turn the printer on and plug the
printer end of the USB cable into
the printer’s USB port.
• For details of how to turn the printer on
and the position of the USB port, refer to
the printer’s instruction manual.
3 Set the camera’s mode dial to q
and plug the USB cable into the
camera’s USB connector.
4 Set the power switch to ON to turn
the camera on.
• ONE MOMENT is displayed and the
camera and printer are connected. The
PRINT MODE SELECT screen is
displayed on the monitor. Make the print
settings on the camera’s monitor. g
Go to “Printing pictures” (P.211).
• If the screen is not displayed after several minutes, turn off the
camera and start again from Step 1.
Power switch
Note
To Next Page
Loading...
