82
External flash (optional)
4
Flash
2 In the top menu, select MODE
MENU → CAMERA → QFLASH.
g“How to use the menus” (P.49)
To use the external flash only
→ Select Q, then press e. Press e
again to exit the menu.
To use the external flash together with
the built-in flash
→ Select IN+Q, then press e. Press e
again to exit the menu.
3 Turn on the external flash.
• Set the mode dial to TTL-AUTO.
• Be sure to attach the flash to the camera
before turning the flash on.
4 Select the flash mode by turning the control dial while
holding down #.
g“Flash shooting” (P.74)
• If close-up pictures are overexposed, try using the built-in flash by
itself.
• When the built-in flash and the external flash are used together, the
built-in flash is used as the compensating light source. This means
that if the amount of light from the external flash is insufficient
(beyond its working range), the resulting pictures may be
underexposed.
Note
To Next Page
Loading...
