Olympus CH Series - Page 51

B 1/8
NOTE:
Apply a small amount of Grease OT2008
to these Balls.
11·2-3
Place the reassembled East-West Drive guide
on
Support frame CHKCOOO3.
(See Fig. 11-6)
11-2-4
Place Casing AA879700 in the middle of
East-West Drive guide AA952000 and set
9 Balls
B-l/8 into the holes of Casing.
(See Fig. 11-6)
CHKC0003
AA952200
AA879700
Fig. 11-6
NOTE:
o Stopper AA502600 can be used as a mark
to center Casing AA879700 on Feed
plate
with.
o Apply a small amount of Grease OT2008
to Balls.
11-2-5
Place Casing AA879700 in the middle of
Feed plate AA952200 and set 9 Balls.
(See Fig. 11-7)
AA879700
__ --81/8
AA502600
AA952200
Fig. 11·7
AA952200
AA952000
o
CHKC0003
o
o
AA502600
11-2-6 Place Feed plate AA952200 (in step 11-24)
on East-West Drive guide AA952000 (in
step 11-2-3).
NOTE:
Align the positions of upper and lower
Casings with each other vertically.
(See Fig. 11-8)
Fig. 11-8
-47 -