Shutter button
Card access
lamp
•
The shutter sounds and the picture is taken.
•
The card access lamp blinks and the camera starts recording the picture.
AF confirmation mark
Aperture
value
Shutter speed
1
Place the AF target on the subject
while viewing through the
viewfinder
2
Adjust the focus
3
Release the shutter
Press the shutter
button halfway.
Viewfinder
Press the shutter button all the
way (fully).
Never remove the battery or card while the card access lamp is blinking. Doing so could destroy
stored pictures and prevent storage of pictures you have just taken.
•
The focus is locked when a beep tone is output. The AF confirmation mark and the AF target in
focus light up in the viewfinder.
•
The shutter speed and aperture value that have been set automatically by the camera are
displayed.
•
The super control panel is not displayed when the shutter button is pressed.
Viewfinder
AF target
Control panel
To Next Page
Loading...
