Playback functions
7
85
EN
7
Playback functions
The basic procedure for viewing pictures are as shown below.
However, before using any of these functions, follow Step 1 below. You can set the camera to
automatically switch to single-frame playback mode after shooting.
g
“REC VIEW” (P. 108)
1
Press the
q
button (Single-frame playback).
•
The last recorded image appears.
•
The LCD monitor turns off after more than 1 minute if no
operations are performed. The camera will turn off
automatically if there is no operation after 4 hours
(factory default setting). Turn on the camera again.
2
Use
p
to select images you want to view. You can
also turn the dial to switch to
U
for close-up
playback.
Single-frame / Close-up playback
j
INFO
button
<
button
p
q
button
k
Press
p
to change the
close-up position.
Press
p
to move the display
of the close-up position.
Press
p
to view frame-by-
frame close-ups.
•
Press the
INFO
button to
return to close-up
playback.
(Single-frame playback) (Close-up playback)
Press the
INFO
button
a
: Displays the frame that is stored 10
frames back
c
: Displays the frame that is stored 10
frames ahead
d
: Displays the next frame
b
: Displays the previous frame
(Close-up position playback)
Press the
INFO
button
(Close-up frame-by-frame playback)
•
To exit the playback mode, press the
q
button.
•
Pressing the shutter button halfway
resumes the shooting mode.
Press the
<
button
•
Plays back the image at a 10x magnified
close-up position.
To Next Page
Loading...
