27
EN
Basic camera operations
1
•
The three buttons next to the flash have two functions
each. Use the main dial to operate and set the
functions indicated above the buttons, and use the
sub dial to operate and set the functions indicated to
the side of the buttons.
After pressing two direct buttons at the same
time, turn the main dial or sub dial.
•
When the buttons are pressed, the corresponding
function is selected. The function remains selected
for approximately 8 seconds. You can turn the dial
and set the function during that time. If no operations
are performed during that time, the setting for that
function is then set.
Setting information is displayed in the viewfinder and on the control panel and super
control panel while you are setting a function. (The setting with the
G
/
AF
button is
shown in the screenshots.)
If you find it difficult to turn the dial while holding down a direct button:
j
The button may remain selected even after it is released.
g
“BUTTON TIMER” (P. 100)
Viewfinder
Control panel Super control panel
TIPS
For details on the functions that can be set with the direct buttons, refer to “Direct
buttons” (
g
P. 4 ) .
NR AF
arge
Normal
2007. 12.16
To Next Page
Loading...
